Passat GLS Wagon L4-1.8L Turbo (AUG) (2001)
^
Pull special tool T 10006 A together with brake pedal towards the driver's seat. (The brake pedal will then be pulled off the ball head of the push
rod).
^
Pull brake pedal from push rod.
^
Pull securing clip -1- from clutch and brake pedal pivot pin -2-.
^
Loosen socket head bolt-3- until it is no longer seated in the groove -arrow-.
^
Push pivot pin -item 2- to the left until the brake pedal can be removed.
^
Remove brake pedal.
Installing
Installation is carried out in the reverse sequence, note the following:
^
Do not tighten socket head bolt -3- until retaining clip has been installed to clutch and brake pedal pivot pin.
Joining brake pedal to brake servo
^
Hold push rod ball head in front of mounting and push brake pedal in direction of brake servo until ball head engage audibly.
^
Adjust brake light switch and, if necessary, brake pedal switch.