Passat GLS Wagon L4-1.8L Turbo (AUG) (2001)
/Page-1693002.png)
^
Remove nuts -2- for brake master cylinder.
^
Remove T45 torx head bolts -2- using 3320 special tool from brake servo unit.
^
Carefully remove brake master cylinder out of brake servo unit.
Installing
^
Installation is in the reverse sequence of removal
Observe the following points when installing:
^
When installing the brake master cylinder and brake servo unit together, make sure that the push rod is correctly located in the brake master
cylinder.
^
Apply slight pressure to the brake pedal in order to move the push rod towards brake master cylinder; this makes it easier to guide brake master
cylinder onto the push rod.
^
After installing, bleed brakes, and clutch.
