Passat GLS Wagon L4-1.8L Turbo (AUG) (2001)
-
Engine must not be more than hand warm.
-
Engine is at TDC cylinder 1.
Work sequence
Tensioning roller up to 07.00 (not adjustable)
-
Tension toothed belt by pulling out T40001 pin and unbolting T10092 tensioning bolt.
Tensioning roller from 08.00 (must be adjusted)
Note: If the toothed belt tensioning device is completely extended, it must be pressed back in installed position with the tensioning roller. This
procedure can take up to 5 minutes. Excessive force during compression can damage tensioning roller.
-
Turn pin wrench counterclockwise (tab -A- of pin wrench must not be bent) using 3387 pin wrench until T10008 locking plate can be removed
without tension.
-
Turn pin wrench to the right in clockwise direction (direction of arrow) until a drill bit -2- with dimension -a- can be pulled through tensioning