Passat GLS Wagon L4-1.8L Turbo (AUG) (2001)
/Page-1050016.png)
Control module, coding (function 07)
When replacing instrument clusters, the CAN- bus On Board Diagnostic Interface -J533- must be coded according to vehicle market version and
equipment level variables.
NOTE: When replacing instrument clusters, CAN-bus On Board Diagnostic interface coding must always be performed, regardless if the correct code is
already stored/appears in the display after inputting address word 79 - Gateway.
Coding
-
Input address word 19 "Gateway" and then press -> button until "Select function XX" is shown in display.
Indicated on display:
Rapid data transfer
HELP
Select function XX
-
Press buttons -0- and -7- to select function "Code control module".
Indicated on display
Rapid data transfer
Q
07-Code Control Module
-
Press -Q- button to confirm input.
Indicated on display:
Coding control module
Enter code number XXXXX (0-32000)
-
Enter code number compiled from code table
Code table
Control Modules
Code number:
connected to CAN-Bus
Automatic Transmission (TCM)
00001
Airbag
00004
Add applicable control module code numbers together to determine the final coding value.
CAUTION!
-
Through January 2000, Gateway coding software did not account for the presence of the ABS control module (as part of the CAN-bus
network). Therefore, the DTC "01044 Control Module incorrectly coded" is loaded into memory. Ignore this DTC!
-
For vehicles through January 2000, DO NOT recode the ABS control module or attempt to use Gateway code values other than those
given in the table above!
-
This software issue was repaired as of February 2000, but still DO NOT recode the ABS control module.
Example: TCM + Airbag: 00001 + 00004 = 00005
-
Use VAG 1551/1552 button pad to enter code: 00005
Indicated on display:
Coding control module
Q
Enter code number 00005 (0-32000)
-
Press -Q- button to confirm input.
Indicated on display:
6N0909901 Gateway K <-> CAN
0001
Coding 00005 WSC 00000
-
Press -> button until "Select function XX" appears in display.
