Passat GLS Wagon L4-1.8L Turbo (AUG) (2001)
-
Press guide link joint pin out of tapered seat.
Note: Do not damage joint protective boot when doing this!
-
Loosen joint pin nut, do not remove completely.
-
Press track-control link joint pin out from tapered seat.
Note: Do not damage joint protective boot when doing this!
-
Remove nut -1-, take out hex bolt and remove both links -2- out upward.
The slits in the wheel bearing housing must not be widened using a chisel or similar tool!
If the hex bolt cannot be removed from the wheel bearing housing, then the hex bolt and the links -2- must be pressed out of the wheel bearing
housing.
-
Swing wheel bearing housing in direction of arrow away to side, when doing this remove drive shaft pin from wheel hub.
-
Remove nut from track-control link joint pin.
-
Take off wheel bearing housing.
Installing
-
Install wheel bearing housing.