Passat GLS Wagon L4-1.8L Turbo (AUG) (2001)
-
Loosen ball housing nuts (arrow-A- and arrow -B-).
-
The ball housing must be set so that it is horizontal.
-
Then tighten ball housing nuts to 25 Nm.
-
Loosen selector rod bolt (arrow).
-
The connection selector rod/selector mechanism must move freely.
-
Align shin lever so that it is positioned slightly to the rear.
-
The distance -a- for both ball stop lugs to ball housing must be equal.
-
Tighten selector rod bolt to 25 Nm.
Functional check
-
The shin lever must rest in the 3rd/4th gear gate when transmission is in neutral.
-
Operate clutch.
-
Select all gears several times. Pay particular attention to the operation of the reverse gear lock.
-
The shin lever must move from the 5th/reverse gear gate into the 3rd/4th gear gate on its own.
Should a gear fail to engage smoothly after repeated selection then continue as follows:
Fine adjustment