Passat GLS Wagon L4-1.8L Turbo (AUG) (2001)
Shifter M/T: Adjustments
Shift Lever Is Not Pressed Down to Engage Reverse Gear
Selector mechanism, adjusting
Notes: The following points are essential to ensure correct selector adjustment:
-
Moving parts of selector mechanism arid transmission elements must be in proper condition.
-
Selector mechanism must move freely.
The transmission, clutch and clutch mechanism must also be in proper condition.
-
Transmission in neutral.
-
Carefully lever the cover off the center console.
-
Then unscrew the shift lever knob with cover.
-
The rubber cover for the shift lever housing must be removed (arrows).
-
Measure distance between body and selector mechanism.
-
Distance -a- must be 41 mm.
-
If this is not the case, adjust dimension -a- as follows:
-
Loosen push rod screw (arrow).
-
The connection push rod/selector mechanism must move freely.
-
Set to dimension -a- by moving selector mechanism.
-
Tighten slide rod bolt (arrow) to 25 Nm.