Passat GLS Wagon L4-1.8L Turbo (AWM) (2002)
lever and housing of tensioning device.
Specified value dimension -a- 8 mm.
-
Hold tensioning roller in this position and tighten securing nut of tensioning roller as follows:
Specified value: 27 Nm
Continuation for all
-
Turn crankshaft two rotations and check whether the camshaft and crankshaft marks align with their reference points.
Tensioning roller from 08.00 (must be adjusted)
-
Check dimension -a- using a drill bit -2 between tensioning lever and housing of tensioning device.
Specified value: 6...10 mm
If dimension -a- is not being reached
-
Repeat procedure
If dimension -a- is being reached
Continuation for all
-
Toothed belt guard, install center and upper part.
-
Install tensioning device for ribbed belt.
Tightening torque: 25 Nm