Passat Sedan L4-1.9L DSL Turbo (AHH) (1998)
Ribbed Belt: Service and Repair
A/C
Ribbed Belt For Compressor -4- Cylinder Engine, Removing And Installing
Special tools, testers, measuring instruments and auxiliary items required
-
Torque wrench (5 - 50 Nm)
Removing
-
Bring front end assembly (lock carrier) into service position. See: Body and Frame/Lock Carrier/Service and Repair/Procedures
NOTE: Before removing ribbed belt, mark direction of rotation. When installing the belt ensure it is correctly seated in the pulley.
-
Loosen ribbed belt tensioner securing bolts - arrows- and remove ribbed belt.
Installing
-
Install and route ribbed belt over compressor and vibration dampener pulleys.
-
Fit torque wrench to tensioner and rotate clockwise -arrow- until tension of 25 Nm (18 ft lb) is reached.
-
Hold torque wrench in place and tighten one of the two securing bolts -A- to 20 Nm (15 ft lb).
-
Tighten securing bolt -A- to 20 Nm (15 ft lb).