Passat Sedan L4-1.9L DSL Turbo (AHH) (1998)
Shift Interlock Solenoid: Service and Repair
Selector Lever Lock Solenoid -N110-, Removing And Installing
Removing
-
Remove shift mechanism. See: Automatic Transmission/Transaxle/Shifter A/T
-
Remove stop buffer from cable lever.
-
Shift selector lever into Tiptronic position, then remove frame.
-
Shift selector lever into position "2"
-
Lift lever for locking cable, detach from mount and remove from mounting bracket.
-
Press out pin for locking pawl with a drift.
-
Lift out selector lever lock solenoid -N110- together with locking pawl.
Installing
-
Shift selector lever into position "2"
-
Insert selector lever lock solenoid -N110- in mounting bracket from above together with locking pawl.
-
Carefully drive in pin for locking pawl.
-
Use a screwdriver to check that the locking pawl is properly engaged when selector lever is in position "P" and "N"
-
Place locking lever in mounting bracket and make sure that it engages properly at both mounts.
-
Check operation of locking lever. With selector lever in position "P" locking lever should engage detent and make it impossible to change gear.
-
Place frame on mounting bracket (ribbed side up) and insert stop buffer in cable lever.
-
Install shift mechanism.