Passat Sedan L4-1781cc 1.8L DOHC Turbo (ATW) (2000)
Shifter A/T: Service and Repair
01V Automatic Transmission
Selector Lever
Selector Lever, Disassembling And Assembling
-
Remove selector lever.
Disassembling
-
Knock out mounting pin for selector lever with a drift.
-
Lift pull rod and slide selector gate out of selector lever together with Tiptronic spring mechanism.
-
Release coil spring, then remove pull rod and coil spring from selector lever.
Assembling
-
Place coil spring -B- onto pull rod -A-.
-
Insert pull rod and coil spring in selector lever.
Installation position: Rounded corner (arrow) and sharp edge point in direction of travel.
-
Ensure pull rod slides freely on two guides -C- on selector lever.
-
Lift pull rod -D- and slide selector gate -B- with Tiptronic spring into selector lever -A-.
-
Drive in mounting pin -C- with a drift.
-
To secure pin peen two new spots (arrows) at 90° to the existing ones.
-
Install selector lever.