Passat Sedan L4-2.0L Turbo (CCTA) (2010)
CAUTION!
Risk of destroying due to reversed running direction on a used ribbed belt.
‹› Before removing ribbed belt, marking running direction with chalk or felt-tip pen for reinstallation later.
‹› Removing and installing => [ Ribbed Belt, Removing and Installing ] See: Ribbed Belt, Removing and Installing
‹› When installing, make sure it is seated correctly on the pulleys
5
Tensioning device for ribbed belt
‹› To release tension on ribbed belt, swing using open-end wrench.
‹› secure with mandrel (T10060 A)
‹› Tensioning device for Ribbed Belt => [ Tensioning device for ribbed belt ]
‹› Passat, Removing and Installing => [ Ribbed Belt Tensioner, Removing and Installing, Passat and Passat CC ] See: Engine, Cooling and
Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Drive Belt Tensioner/Service and Repair
‹› Removing and Installing, Rabbit, Eos and Scirocco.
‹› Removing and Installing, Tiguan.
6
Bracket for assemblies
‹› with Oil Pressure Switch (F1), oil filter and oil cooler
‹› Accessory Assembly Bracket, Removing and Installing => [ Accessory Assembly Bracket, Removing and Installing ] See: Engine, Cooling
and Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Engine Accessory Bracket/Service and Repair
‹› Oil cooler, removing and installing => [ Oil Cooler, Removing and Installing ] See: Engine, Cooling and Exhaust/Engine/Engine
Lubrication/Oil Cooler/Service and Repair
7
Bolt
‹› 10 Nm
8
Alternator
‹› Removing and installing
9
Bolt
‹› 23 Nm
10
Bolt
‹› Tightening order => [ Accessory assembly bracket tightening sequence ]
11
A/C Compressor
‹› Do not remove or disconnect refrigerant lines
‹› Removing and installing
12
Bolt
‹› 25 Nm
13
Alignment bushing
‹› For air conditioning compressor
Tensioning device for ribbed belt