volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Diagram Information and Instructions|Page 908 > < Diagram Information and Instructions|Page 906
Page 1
background image

Wiper Switch: Service and Repair

Steering Column Layout

1- Driver air bag
2- Hex nut 40 Nm (29 ft lb)
3
- Steering wheel with coil spring for air bag
4- Steering column switch securing screws
5- Switch for turn signals, cruise control system, high and low beam head light, flasher and emergency light switch
6- Switch for windshield wiper and wipe/wash operation
7- Column tube
8- Steering column
9- Support ring

10- Steering column lock housing securing bolt 10 Nm (7 ft lb)
11
- Steering lock housing
12- Ignition/starter switch. Remove steering lock housing, then remove securing screws
13- Contact ring
14- Lock cylinder
15- Spring
16- Clamping washer

Windshield Wiper Switch Replacement

Warning:  Special safety precautions and some different procedures apply to vehicles equipped with airbags. See: Restraint Systems/Air Bag Systems 

Caution:  Before working on the electrical system:

Determine the correct coding for the anti-theft radio.
Disconnect the battery Ground (GND) strap.
Be sure the ignition is switched OFF (also applies when connecting the battery). Failure to do so may damage the Engine Control Module (ECM).
Disconnecting the battery causes the basic setting of ECM to be erased. This may result in driveability problems.

Removing:

Diagram Information and Instructions|Page 908 > < Diagram Information and Instructions|Page 906