Passat Sedan V6-2792cc 2.8L DOHC (AAA) SFI (1997)
Fig. 4 - Inner Constant Velocity Joint, Pressing On
-
Press on joint up to stop.
-
Install circlip.
NOTE: Chamfer on inner diameter of ball hub (splines) must face the contact shoulder on the drive shaft.
Fig. 5 - Installation Position Of Left Drive Shaft Transmission End Joint Boot, Rubber Version
-
Dimension " a " = 17 mm
NOTE:
-
Before assembling boot on drive shaft mark position, dimension "a", with for example paint or adhesive tape.
-
Under no circumstances should paint surface be damaged with a sharp tool.
Fig. 6 - Installation Position Of Right Drive Shaft Transmission End Joint Boot
-
The large diameter of vent chamber -A- must fit on the larger diameter.
-
-B-Vent hole
Fig. 7 - Joint Boot, Ventilating
-
Often the boot is pushed in when installing on the joint body.
-
This creates a vacuum inside the boot which draws a fold in (arrow) while driving.
-
After installing, lift the boot at small diameter end to equalize pressure.