Passat Sedan V6-2792cc 2.8L DOHC (AAA) SFI (1997)
Selector Shaft: Service and Repair
COMPONENT NOTES AND INFORMATION
1
Selector shaft
2
Stop ring
3
Ball sleeve
-
Removing, refer to Fig. 1
-
Installing, refer to Fig. 2
4
Oil seal
-
Pry out with screwdriver
-
Installing, refer to Fig. 3
5
Cover
6
Sleeve
-
Tab faces Back-Up Light Switch
-
Lightly lubricate tab with MoS2 grease
7
Self-locking nut
-
Tighten to: 25 Nm (18 ft lb)
-
Always replace
8
Housing With Back-Up Light Switch
9
Bolt
10
Cap
-
For transmission breather
11
Sleeve
-
Drive in to stop
12
Transmission gearshift lever
-
Install so that master spline aligns with selector shaft
-
Can be replaced with selector mechanism installed. -a-.
-
Installation position, refer to Selector Lever/Relay Lever Installation Position. See: Service and Repair
-
Replacing, refer to Fig. 4
13
Relay lever
-
Installation position, refer to Selector Lever/Relay Lever Installation Position. See: Service and Repair
14
Nut
-
Tighten to: 15 Nm (11 ft lb)
15
Actuating arm
-
With shaft for mounting relay lever
-
Installation position, refer to Selector Lever/Relay Lever Installation Position. See: Service and Repair
16
Bolt
-
Press into actuating arm