Passat Sedan V6-2792cc 2.8L DOHC (AAA) SFI (1997)
19
Circlip
20
Sleeve
-
Where applicable
21
Lock washer
-
Removing and installing, refer to Fig. 2, below.
22
Spacer sleeve
23
Spring
24
Shift lever guide
25
Shift lever
26
Damping washer
Fig. 1 Installing gate selector housing cap
-
Press on from side (-arrow-)
-
Press together opening to form a slot
NOTE: Heat cap to soften if necessary (e.g. in hot water).
Fig. 2 Removing and installing lock washer
-
Pull shift lever in direction of arrow -A- and simultaneously use screwdriver to push spacer bushing in direction of arrow -B- to stop
NOTE:
^
Do not tilt the spacer bushing when pushing down.
^
The holding slot in the shift lever for the lock washer must remain accessible.
Fig. 3 Removing circlip for selector bracket and shift lever guide/selector housing
-
Lift clamp in direction of -arrow-.