Passat Sedan V6-2792cc 2.8L DOHC (AAA) SFI (1997)
-
Clamp selector shaft in a vise (with jaw protectors), then using a pair of pliers try to rotate clamping sleeve -A- on selector shaft.
If sleeve rotates:
-
Install new selector shaft
Part No: 02A 301 233F into selector shaft housing (ensure that selector shaft moves freely in housing).
-
Remove new selector shaft from housing and install into transmission.
-
Install selector shaft housing using sealant AMV 188 200 03 or equivalent.
^
Torque bolts to 25 Nm. (18 ft. lb.).
-
Reinstall gear shift lever.
-
Reinstall back-up light switch cam sleeve (always use a new self locking nut).
^
Torque nut to 25 Nm. (18 ft. lb.).
-
Lift lug -C- in direction of -arrow- and reinstall gate selector cable to actuating arm/relay lever.
-
Reconnect gear selector cable to gear selector lever (position cable pivot in center of slot on selector lever).
-
Reinstall balance weight -A-.
-
Reinstall back-up light switch housing -D-.
-
Reinstall back-up light switch electrical connector.
-
Road test vehicle.
When procedure applies to vehicles within warranty use the following: