Volkswagen Workshop Manuals
Passat Sedan V6-3.6L (BLV) (2008)
Brakes and Traction Control > Disc Brake System > Brake Caliper > Component Information > Service and Repair > Removal and Replacement > Page 4369
‹› 4 Nm
‹› Bolt to wheel bearing housing
‹› Insert in brake pad retaining spring and press below brake carrier.
‹› 190 Nm
‹› Clean if using again.
‹› Thickness: 14 mm without backing plate
‹› With wear indicator
‹› When wear limit is reached (limit: approximately 4 mm), the warning lamp lights up in instrument cluster
‹› Wear limit: 2 mm without backing plate
‹› Check the thickness.
‹› Must always be replaced together on both sides of axle
‹› Removing and installing, refer to => [ Brake Pads ] See: Front Brakes, FNR-G Brake Caliper
‹› Do not bolt to brake hose/brake line when changing brake pads
‹› Must not be removed
‹› Removing and installing, refer to => [ Brake Caliper ] See: Front Brakes, FNR-G Brake Caliper
‹› Servicing, refer to => [ Front Brake Caliper Assembly Overview, FNR-G ] See: Front Brake Caliper Assembly Overview, FNR-G
‹› 30 Nm
‹› 10 Nm
‹› 15 Nm
|[PREV PAGE] [NEXT PAGE]|