Passat Sedan V6-3.6L (BLV) (2008)
-
Disconnect knock sensor and vacuum hose valve connectors at rear of intake manifold. Unclip wiring harness from retainers on coolant pipe and
lay it aside.
-
Remove vacuum hoses on rear of intake manifold, remove from retainers and set aside completely.
-
Loosen right rear coolant pipe from left and rear of engine.
-
Disconnect both coolant hoses on reservoir with hose clamps up to 25 mm dia. (3094).
-
Now remove both coolant hoses on reservoir and then set them as far aside as possible with coolant pipe.
All Vehicles
-
On vehicles with heat shield, remove heat shield.
-
Press the red securing clip in direction of - arrow - toward the rear.
-
Release and remove connector from control module in direction of - arrow -.
-
Insert (V.A.G 1869/2).
-
Attach bleeder hose of bleeder bottles to left-front and left-rear brake caliper bleeder valves and open bleeder valves.
-
Operate brake pedal using (V.A.G 1869/2) at least 60 mm.
-
Close left front and left rear bleeder valves.
-
Do not remove (V.A.G 1869/2).