Passat Sedan V6-3.6L (BLV) (2008)
Checking voltage
-
Switch the ignition on.
-
Using a multimeter, Check the Camshaft Adjustment Valve 1 Intake (N205) or Camshaft Adjustment Valve 1 Exhaust (N318) electrical harness
connector terminal 1 to ground for voltage.
-
Switch the ignition off.
Specified value: battery voltage.
If the specified value was not obtained:
-
Check the wiring connection from terminal 1 to fuse 8 in Fuse Panel B for an open circuit, high resistance or short circuit to ground.
-
Check the wiring connection for damage, corrosion, loose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If the specified value was obtained:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the test box.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Motronic Engine Control Module (ECM) (J623). Refer to the Repair Information.
-
Using a, Check the Camshaft Adjustment Valve 1 Intake (N205) or Camshaft Adjustment Valve 1 Exhaust (N318) electrical harness connector
terminal 2 to the Motronic Engine Control Module (ECM) electrical harness connector for an open circuit.
Specified value: 1.5 ohms Max.
If the specified value was not obtained: