Passat Sedan V6-3.6L (BLV) (2008)
-
Remove the seal and clean the groove - arrow -. Remove any deposits (coking) using a brass wire brush.
-
Install the new seal - 1 - onto the (T10133/5). Slide the seal onto the (T10133/5) as far as it will go using (T10133/6) (the knurl faces toward the
seal - 1 -).
-
Turn the assembly sleeve (T10133/6) around so the knurled side no longer faces the seal. Slide the seal - 1 - to the end of the (T10133/5).
-
Install the (T10133/5) with the seal onto the fuel injector. Slide the seal farther on the injector using (T10133/6).
The seal is not in the groove yet.