Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Passat Sedan V6-3.6L (BLV) (2008)

Maintenance > Wheels and Tires > Wheel Bearing > Component Information > Service and Repair > Procedures > Page 1774

Page 8
background image

-

Remove brake carrier with brake caliper and hang on body with tie wire.

‹› Suspend brake caliper from body.

-

Remove brake disc bolt and take out brake disc.

-

Remove multi-point socket head bolt using bit XZN 18 (T10162).

-

Pull wheel hubs/wheel bearing unit off stub axle.

Installing

-

Carefully slide wheel hub/wheel bearing unit onto stub axle.

‹› Make sure that wheel hubs/wheel bearing unit do not cant!

-

Tighten using a new multi-point socket head bolt.

‹› First tighten bolt to specified tightening specification using torque wrench.

‹› Use solid wrench for additional torque angle.

-

Drive in dust cap using (3241/4).

‹› Always replace dust caps.

‹› Damaged dust caps allow moisture to enter. Therefore, always use the tool shown.

Rest of installation is the reverse of removal.

Maintenance > Wheels and Tires > Wheel Bearing > Component Information > Service and Repair > Procedures > Page 1774

[PREV PAGE] [NEXT PAGE]