Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Passat Sedan V6-3.6L (BLV) (2008)

Power and Ground Distribution > Wiring Harness > Component Information > Service and Repair > Procedures > Page 5582

Page 18
background image

-

Slide a single wire seal onto the repair wire.

‹› When doing this, small diameter of single seal must point toward contact housing.

-

Slide single wire seal into contact housing using the correct assembly tool. Refer to => [ Single Wire Seals ] See: Description and
Operation/Single Wire Seals.

-

Shorten the repair wire and the vehicle-specific wiring harness single wire as needed using the Wire Stripper (VAS 1978/3).

-

Strip ends of repair wire and of vehicle-specific single wire using 6 - 7 mm wire stripper.

-

Crimp the stripped ends of repair wire and single wire of vehicle-specific wiring harness using crimp pliers and a crimp connection as described in

Power and Ground Distribution > Wiring Harness > Component Information > Service and Repair > Procedures > Page 5582

[PREV PAGE] [NEXT PAGE]