Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Passat Sedan V6-3.6L (BLV) (2008)

Powertrain Management > Computers and Control Systems > Camshaft Position Sensor > Component Information > Locations > Page 2961

Page 1
background image

Camshaft Position Sensor: Testing and Inspection

Diagnostic Procedures

Camshaft Position Sensor 1 G40 or Sensor 2 G163 Checking

Special tools, testers and auxiliary items required

‹› Multimeter.

‹› Wiring diagram.

Test requirements

‹› The Motronic Engine Control Module (ECM) (J623) fuses OK.

‹› Battery voltage at least 12.5 volts.

‹› All electrical consumers such as, lights and rear window defroster, switched off.

‹› Vehicles with automatic transmission, shift selector lever into position " P" or "N".

‹› A/C switched off.

‹› Ground connections between engine/transmission/chassis OK.

‹› Ignition switched off.

Test procedure

-

Observe safety precautions. Refer to => [ Safety Precautions ] See: Service Precautions/Safety Precautions

-

Observe Clean Working Conditions. Refer to => [ Clean Working Conditions ] See: Service Precautions/Clean Working Conditions

-

Perform a preliminary check to verify the customers complaint. Refer to => [ Preliminary Check ] See: Testing and Inspection/Scan Tool Testing
and Procedures/Preliminary Check.

Start diagnosis

-

Disconnect the Camshaft Position (CMP) Sensor electrical harness connector - 10 -.

Powertrain Management > Computers and Control Systems > Camshaft Position Sensor > Component Information > Locations > Page 2961

[PREV PAGE] [NEXT PAGE]