Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Passat Sedan V6-3.6L (BLV) (2008)

Powertrain Management > Computers and Control Systems > Coolant Temperature Sensor/Switch (For Computer) > Component Information > Testing and Inspection > Engine Coolant Temperature Sensor G62, Checking > Page 2974

Page 3
background image

Specified values:

-

Range A, 30 degrees C equals a resistance of 1.5 to 2.0 k Ohms

-

Range B, 80 degrees C equals a resistance of 275 to 375 Ohms

If any of the specified values was not obtained:

-

Replace the the Engine Coolant Temperature (ECT) Sensor G83 Engine Mechanical, Fuel Injection Ignition.

Testing if display is approx. - 40.0 degrees C:

-

Disconnect the Engine Coolant Temperature (ECT) Sensor G83 electrical harness connector - 1 -.

-

Using a jumper wire, connect the Engine Coolant Temperature (ECT) Sensor (on radiator) G83 electrical harness connector terminals 1 to 2.

-

Check the value indicated on the scan tool display.

If the value jumps to approx. 140.0 degrees C

-

End diagnosis and switch the ignition off.

-

Replace the the Engine Coolant Temperature (ECT) Sensor G83 Engine Mechanical, Fuel Injection Ignition.

If indication remains at approx. -40.0 degrees C:.

Testing if display approx. 140.0 degrees C:

Powertrain Management > Computers and Control Systems > Coolant Temperature Sensor/Switch (For Computer) > Component Information > Testing and Inspection > Engine Coolant Temperature Sensor G62, Checking > Page 2974

[PREV PAGE] [NEXT PAGE]