Volkswagen Workshop Manuals
Passat Sedan V6-3.6L (BLV) (2008)
Powertrain Management > Computers and Control Systems > Fuel Pressure Sensor > Component Information > Technical Service Bulletins > All Technical Service Bulletins for Fuel Pressure Sensor: > 0110-10 > Jun > 10 > Fuel System - MIL ON/DTC' P129F/P310B Set > Page 3046
c. If problem persists, further fuel system diagnosis is required.
Some technicians may still wish to use a mechanical gauge to check fuel pressure.
To verify low side fuel pressure, a mechanical fuel pressure gauge may be connected in the engine compartment (figure 1).
Add 1 bar (14.5 psi) to value obtained from mechanical gauge to calculate adjusted gauge measurement.
Compare adjusted gauge measurement to value stored in MVB 103 field 1.
VAG 1318 gauge installed on a 2.0T FSI vehicle.
MVB 103 field 1 value should be approximately 1 bar (14.5 psi) above mechanical gauge reading. This is a normal condition and does not indicate a
|[PREV PAGE] [NEXT PAGE]|