Passat Sedan V6-3.6L (BLV) (2008)
Transmission Position Switch/Sensor: Adjustments
Multifunction Transmission Range Switch, Adjusting
Special tools, testers and auxiliary items required
‹› Setting Gauge (T10173)
Place the selector lever in the "N" position.
Do not kink the selector lever cable.
‹› Selector lever cable is disconnected from the selector shaft lever
‹› Shift rod is in the "N" position
‹› Bolts for the multifunction transmission range switch (F125) are loosened
‹› Lever/shift rod is removed
Install the (T10173) onto the shift rod - 2 - and turn the multifunction switch - 1 - until the (T10173) engages on the connector tab of the
Tighten the (T10173) to the shift rod - 2 - using bolt - 3 -.
Tighten the multifunction switch bolts - arrows - to 6 Nm.
Remove the (T10173).
Further installation is performed in the reverse sequence. Refer to => [ Installing ] See: Service and Repair.