Passat Sedan V6-3.6L (BLV) (2008)
Installing
-
when reusing an oxygen sensor, only use hot bolt paste (G 052 112 A3) to lubricate the threads; do not let the paste get onto the slits of the oxygen
sensor body.
-
Install the HO2S - 1 - into the bank 1 exhaust pipe. Identifying feature: black connector.
-
Install the HO2S 2 - 2 - into the bank 1 exhaust pipe. Identifying feature: brown connector.
Tightening specifications: 50 Nm
-
Install the original wiring again.
Further installation is performed in reverse order.
4-Pin Heated Oxygen Sensor
4-Pin Heated Oxygen Sensor
‹› Do not repair the oxygen sensor wires. Repairing may result in malfunctions.
‹› Use the faulty sensor as a guide for installing all of the accompanying attachments, cable ties or marking bands.
‹› If necessary, identify the heated oxygen sensor (HO2S) using the protective tube. Refer to => [ Oxygen Sensor Unit Protective Pipes ] See: Power
and Ground Distribution/Wiring Harness/Description and Operation/Oxygen Sensor Unit Protective Pipes.
-
Remove the faulty oxygen sensor.
-
Lay both of the oxygen sensor next to each other so the sensor housings are the same level.