Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Passat Sedan V6-3.6L (BLV) (2008)

Powertrain Management > Sensors and Switches - Powertrain Management > Sensors and Switches - Computers and Control Systems > Oxygen Sensor > Component Information > Testing and Inspection > HO2S Front Oxygen Sensor Bank 1 Sensor 1, Checking > Page 2775

Page 25
background image

If the DTC does return, no malfunction is detected in the wiring and the voltage supply is OK:

-

Replace the Motronic Engine Control Module (ECM) (J623). Refer to the Repair Information.

-

Assembly is performed in the reverse of the removal.

Final procedures

After repair work, the following work steps must be performed in the mentioned sequence:

1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] See: Computers and Control Systems/Testing and

Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09. 

2. If necessary, erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Computers and Control Systems/Testing and

Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09.

3. If the DTC memory was erased, generate readiness code. Refer to => [ Readiness Code ] See: Computers and Control Systems/Testing and

Inspection/Monitors, Trips, Drive Cycles and Readiness Codes.

Powertrain Management > Sensors and Switches - Powertrain Management > Sensors and Switches - Computers and Control Systems > Oxygen Sensor > Component Information > Testing and Inspection > HO2S Front Oxygen Sensor Bank 1 Sensor 1, Checking > Page 2775

[PREV PAGE] [NEXT PAGE]