volkswagen Workshop Repair Guides

Volkswagen Workshop Manuals

< PREV PAGE NEXT PAGE >
Page 7
background image

NOTE

If a connection error is indicated for Seat
Occupant Recognition Module not
found", an "ERROR" indicator on the VAS
5052 / VAS 6150 screen is highlighted.

^

Check all connections.

^

Restart application by pressing EXIT".

^

Switch ignition key ON and then OFF

^

Begin procedure again.

If error continues, try rebooting scan tool and re attempt to perform programming update.

After programming is complete or verified flash was already applied,

^

Disconnect VAS 6103/2 pods connector and VAS 6103 from scan tool.

^

Reconnect 5052/3 diagnostic cable to VAS 5052 I VAS 6150 tester and reconnect vehicle Data Link Connector.

^

Reconnect and lock Seat Occupant Recognition Module 10 pin connector to body 10 pin connector. Be sure that the connector snaps locked.

^

Switch ignition ON.

Relays and Modules > Relays and Modules - Restraint Systems > Seat Occupant Classification Module - Air Bag > Component Information > Technical Service Bulletins > All Technical Service Bulletins for Seat Occupant Classification Module - Air Bag: > 6911-01 > Feb > 11 > Restraints - Air Bag Lamp ON/DTC 02511 014 Stored > Page 344

< PREV PAGE NEXT PAGE >