Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Passat Sedan V6-3.6L (BLV) (2008)

Sensors and Switches > Sensors and Switches - Restraint Systems > Impact Sensor > Component Information > Service and Repair > Drivers Front Airbag Crash Sensor G283 > Page 1072

Page 5
background image

-

Connect connector - 4 - to Front Passenger Side Airbag Crash Sensor (G179) - 3 -.

-

Secure Front Passenger Side Airbag Crash Sensor (G179) with pop rivet - 2 - to subframe using Pop rivet pliers (VAS 5072).

-

Secure Front Passenger Side Airbag Crash Sensor (G179) with pop rivet - 1 - to subframe as described. 

-

Further installation is in reverse order of removal.

-

Switch on ignition.

CAUTION!
Make sure that no persons are in the vehicle.

-

Connect vehicle battery.

Inside of Subframe

Removing

CAUTION!
Read the Safety Instructions for working with airbags, belt tensioners and battery cut-out units.

-

Disconnect vehicle battery.

Sedan and Wagon

-

Remove driver side front door trim. Refer to => [ Driver Side Front Door Trim ] See: Body and Frame/Doors, Hood and Trunk/Doors/Front
Door/Front Door Panel/Service and Repair

Sensors and Switches > Sensors and Switches - Restraint Systems > Impact Sensor > Component Information > Service and Repair > Drivers Front Airbag Crash Sensor G283 > Page 1072

[PREV PAGE] [NEXT PAGE]