Volkswagen Workshop Manuals
Passat Sedan V6-3.6L (BLV) (2008)
Sensors and Switches > Sensors and Switches - Restraint Systems > Seat Occupant Sensor > Component Information > Service and Repair > Passive Occupant Detection System (Overview) > Page 1099
Passive Occupant Detection System Repair Kit, Manual Seats
‹› When installing, there must be no wiring harness of seat heater between upholstery and mat for seat occupied recognition.
‹› Pressure hose must be routed without kinking.
‹› Stickers with notes on harness connectors must not be damaged.
‹› After vehicle was connected to electrical system, check replaced components for freedom of movement by moving seat.
After replacing seat occupied recognition, basic setting of seat occupied recognition must be performed using diagnostic tester containing "Guided
To install, perform the steps used for removal in reverse order.
While doing so, observe the following notes.
Secure insert profile - 2 - to seat frame - 1 - as shown, using double-sided adhesive tape - 3 -.
|[PREV PAGE] [NEXT PAGE]|