Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Passat Sedan V6-3.6L (BLV) (2008)

Starting and Charging > Power and Ground Distribution > Wiring Harness > Component Information > Service and Repair > Procedures > Page 5237

Page 20
background image

‹› These contacts can be removed at every other contact housing in the event they are not required.

‹› Repair wires which have already been equipped with corresponding contacts crimped on are available.

Wiring Eyelets, Repairing

Wiring Eyelets, Repairing

Special tools, testers and auxiliary items required

‹› Torque wrench 5-50Nm (VAG1331)

‹› Do not use rust remover, contact spray or grease because the lack of friction will cause the torque to be exceeded when installing and this will lead

to the threaded connection breaking.

‹› The gray sanding pads are for slight contamination and suitable for "soft surfaces". The red sanding pads are for heavy contamination and suitable

for "hard surfaces".

CAUTION!
Risk of injury. Observe warning notes and safety precautions. Refer to => [ Battery Safety Precautions ] See: Battery/Service
Precautions/Battery Safety Precautions and => [ Battery Safety Designation ] See: Battery/Service Precautions/Battery Safety
Designation!

-

Disconnect battery.

-

Loosen the cap nut and remove the wiring eyelet from the threaded connection.

Starting and Charging > Power and Ground Distribution > Wiring Harness > Component Information > Service and Repair > Procedures > Page 5237

[PREV PAGE] [NEXT PAGE]