Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Passat Sedan V6-3.6L (BLV) (2008)

Starting and Charging > Power and Ground Distribution > Wiring Harness > Component Information > Service and Repair > Procedures > Page 5245

Page 3
background image

Flat connector system with one retaining tab:

-

Guide the release tool which fits the terminal housing into release channel on terminal housing.

-

Grasp contact at wire and push it gently into terminal housing - arrow -.

NOTE:  By pushing contact in direction of terminal housing, retaining tab of contact is lifted off the housing shoulder and can be released using
the release tool.

-

At the same time, push release tool in direction of terminal housing and pull the released contact out of terminal housing - arrow -.

-

After removing the contact, release tool can be pulled out of terminal housing again.

Flat connector system with two retaining tabs:

-

Guide the release tool which fits the terminal housing into release channel on terminal housing.

-

Grasp contact at wire and push it gently into terminal housing until it stops - arrow -.

NOTE:  By pushing contact in direction of terminal housing, retaining tabs of contact are lifted off the housing shoulder and can be released using
the release tool.

Starting and Charging > Power and Ground Distribution > Wiring Harness > Component Information > Service and Repair > Procedures > Page 5245

[PREV PAGE] [NEXT PAGE]