Volkswagen Workshop Manuals
Passat Sedan V6-3.6L (BLV) (2008)
Steering and Suspension > Sensors and Switches - Steering and Suspension > Sensors and Switches - Suspension > Ride Height Sensor, Suspension Control > Component Information > Service and Repair > Front Suspension > Page 5747
‹› Torque wrench (V.A.G 1331)
‹› Vehicle Diagnosis, Testing and Information System (VAS 5051)
Disconnect the connector.
Remove the bolts.
Remove left rear level control system sensor.
Installation is performed in the reverse order of removal. Observe the following when doing so:
The level control system sensor lever must point toward vehicle exterior.
Perform a basic setting on the adaptive chassis DCC. Refer to => [ Adaptive Chassis DCC, Basic Setting ] See: Suspension/Suspension Control (
Perform a basic setting on the headlamps via the Guided Fault Finding function using the (VAS 5051).
Front Wheel Drive (FWD)
Left Rear Level Control System Sensor Assembly Overview, from MY 2008
‹› Assembly Overview for adaptive chassis DCC, FWD, refer to => [ Left Rear Level Control System Sensor Assembly Overview, FWD ] See: Left
Rear Level Control System Sensor Assembly Overview, FWD.
‹› Vehicle level sensor is available as replacement part only complete with coupling rod and upper and lower retaining plates.
‹› Replacing with subframe installed. Refer to => [ Left Rear Level Control System Sensor, from MY 2008 ] See: Suspension/Service and
Repair/Removal and Replacement/Rear Suspension/Front Wheel Drive (FWD).
|[PREV PAGE] [NEXT PAGE]|