Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Passat Sedan V6-3.6L (BLV) (2008)

Steering and Suspension > Wheels and Tires > Wheel Fastener > Component Information > Service and Repair > Wheel Bolt Tightening Specification

Page 1
background image

Wheel Fastener: Service and Repair
Wheel Bolt Tightening Specification

03 - Service Procedures

Wheel Bolt Tightening Specification

Removing Wheel Center Cap

CAUTION!
On vehicles with alloy wheels, do not pry out center wheel cap with screwdriver. Rather, use special tool designed for this purpose (puller
hook in vehicle tool kit).

Extractor - 1 - for removing cover cap is located in vehicle tool kit.

-

Insert removal hook into one of the holes of the wheel center cap and pull in - direction of arrow -.

-

On vehicles with full covers, install full wheel cover by guiding the tire inflating valve through the designated recess - arrow -. 

Removing Wheel Bolt Caps

CAUTION!
On vehicles with alloy wheels, do not pry out wheel bolt cover caps with screwdriver. Rather, use special tool designed for this purpose
(puller hook in vehicle tool kit).

‹› Wheel bolt cover caps must be removed before wheel bolts can be loosened. 

The pulling hook for removing the cover caps is located in the vehicle tool kit.

Steering and Suspension > Wheels and Tires > Wheel Fastener > Component Information > Service and Repair > Wheel Bolt Tightening Specification

[PREV PAGE] [NEXT PAGE]