Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Passat Sedan V6-3.6L (BLV) (2008)

Transmission and Drivetrain > Automatic Transmission/Transaxle > Actuators and Solenoids - A/T > Shift Solenoid, A/T > Component Information > Locations > Page 3828

Page 1
background image

Shift Solenoid: Service and Repair

Solenoid Valve and Sensor Wiring Harness

Removing

-

Drain the Automatic Transmission Fluid (ATF). Refer to => [ Automatic Transmission Fluid, Draining and Filling ] See: Fluid - A/T/Service and
Repair/Automatic Transmission Fluid, Draining and Filling.

-

Remove the valve body. Refer to => [ Valve Body ] See: Valve Body/Service and Repair/Valve Body.

-

Disconnect the connector from the transmission.

1 - transmission sensor terminal

2 - connector for solenoid valves

-

Disconnect the connector housing from the transmission.

-

Disconnect the connector housing together with the wiring harness outward from the transmission housing.

Installing

-

Replace the seal on the connector housing.

-

Carefully guide the wiring harness from the outside into the transmission.

-

Lubricate the connector housing seal with ATF and then press the connector housing all the way into the transmission.

-

Connect the connector housing. Tightening specification, refer to => [ Fastener Tightening Specifications ] See: Valve
Body/Specifications/Fastener Tightening Specifications - Gears, Hydraulic Controls.

-

Install the valve body. Refer to => [ Valve Body ] See: Valve Body/Service and Repair/Valve Body.

-

Add the ATF, check the ATF level and top off if necessary. Refer to => [ Automatic Transmission Fluid Level, Checking and Filling ] See: Fluid -
A/T/Service and Repair/Automatic Transmission Fluid Level, Checking and Filling.

Transmission and Drivetrain > Automatic Transmission/Transaxle > Actuators and Solenoids - A/T > Shift Solenoid, A/T > Component Information > Locations > Page 3828

[PREV PAGE] [NEXT PAGE]