Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Passat Sedan V6-3.6L (BLV) (2008)

Transmission and Drivetrain > Automatic Transmission/Transaxle > Fluid - A/T > Component Information > Service and Repair > Automatic Transmission Fluid Level, Checking and Filling > Page 3852

Page 2
background image

Checking

-

Turn off the engine.

The ATF temperature must not be more than approximately 30 °C (86 °F) at the start of the test.

‹› Transmission is not in the emergency running, ATF temperature not above approximately 30° C (86 °F).

‹› Vehicles is on a flat, level surface.

‹› The selector level is in the "P" position.

-

Connect the vehicle tester and scroll through the selections until it is ready for operation. Refer to => [ Vehicle Tester, Connecting and Selecting
Functions ] See: Shifter A/T/Testing and Inspection/Scan Tool Testing and Procedures.

-

Press the right button Guided Functions.

-

Then select the vehicle, transmission and Check ATF Level.

-

Press ->.

-

Start the engine.

-

Raise the vehicle.

-

Place an appropriate receptacle underneath the transmission.

-

Press ->.

If the test temperature shown is 35 to 45 °C (95 to 113 °F):

-

Remove the inspection plug from the oil pan to check the ATF.

Transmission and Drivetrain > Automatic Transmission/Transaxle > Fluid - A/T > Component Information > Service and Repair > Automatic Transmission Fluid Level, Checking and Filling > Page 3852

[PREV PAGE] [NEXT PAGE]