Passat Sedan V6-3.6L (BLV) (2008)
Shift Solenoid: Service and Repair
Solenoid Valve and Sensor Wiring Harness
Removing
-
Drain the Automatic Transmission Fluid (ATF). Refer to => [ Automatic Transmission Fluid, Draining and Filling ] See: Fluid - A/T/Service and
Repair/Automatic Transmission Fluid, Draining and Filling.
-
Remove the valve body. Refer to => [ Valve Body ] See: Valve Body/Service and Repair/Valve Body.
-
Disconnect the connector from the transmission.
- 1 - transmission sensor terminal
- 2 - connector for solenoid valves
-
Disconnect the connector housing from the transmission.
-
Disconnect the connector housing together with the wiring harness outward from the transmission housing.
Installing
-
Replace the seal on the connector housing.
-
Carefully guide the wiring harness from the outside into the transmission.
-
Lubricate the connector housing seal with ATF and then press the connector housing all the way into the transmission.
-
Connect the connector housing. Tightening specification, refer to => [ Fastener Tightening Specifications ] See: Valve
Body/Specifications/Fastener Tightening Specifications - Gears, Hydraulic Controls.
-
Install the valve body. Refer to => [ Valve Body ] See: Valve Body/Service and Repair/Valve Body.
-
Add the ATF, check the ATF level and top off if necessary. Refer to => [ Automatic Transmission Fluid Level, Checking and Filling ] See: Fluid -
A/T/Service and Repair/Automatic Transmission Fluid Level, Checking and Filling.