Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Passat Sedan V6-3.6L (BLV) (2008)

Transmission and Drivetrain > Drive/Propeller Shafts, Bearings and Joints > Drive/Propeller Shaft > Component Information > Service and Repair > Removal and Replacement > Page 4138

Page 4
background image

Installing Flange

Intermediate Bearing, Removing

-

Tension the separating device - A - with the straights sides of the cuts behind the intermediate bearing.

-

Then position the two arm puller -  - on the separating device.

-

Remove the intermediate bearing from the driveshaft.

A Separating tool 12 to 75 mm, e.g. (Kukko 17/1)
B Two arm puller, e.g. (Kukko 20/10)

Intermediate Bearing, Installation Position 

Transmission and Drivetrain > Drive/Propeller Shafts, Bearings and Joints > Drive/Propeller Shaft > Component Information > Service and Repair > Removal and Replacement > Page 4138

[PREV PAGE] [NEXT PAGE]