Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


Passat Sedan V6-3.6L (BLV) (2008)

Transmission and Drivetrain > Flex Plate > Component Information > Specifications > Page 4153

Page 2
background image

‹› Crankshaft overview. Refer to => [ Crankshaft Overview ] See: Engine, Cooling and Exhaust/Engine/Cylinder Block

Assembly/Crankshaft/Service and Repair/Crankshaft Overview.

‹› Piston and connecting rod overview. Refer to => [ Piston and Connecting Rod Overview ] See: Engine, Cooling and Exhaust/Engine/Cylinder

Block Assembly/Piston/Service and Repair/Piston and Connecting Rod Overview.

6

Sealing Flange

‹› Removing and installing, refer to => [ Sealing Flange, Transmission Side ] See: Engine, Cooling and Exhaust/Engine/Cylinder Block

Assembly/Crankshaft Seal Retainer/Service and Repair.

7

Seal

‹› Remove using pulling hook (T20143/2).

‹› Polytetrafluoroethylene (PTFE) version of the oil seal.

‹› Do not lubricate or grease the sealing lip on the oil seal.

‹› Before installing, remove any remaining oil from crankshaft with a clean cloth.

‹› Installing, refer to => [ Sealing Flange Seal, Transmission Side ] See: Engine, Cooling and Exhaust/Engine/Seals and Gaskets/Crankshaft Main

Bearing Seal/Service and Repair/Sealing Flange Seal, Transmission Side.

8

Shim

9

Bolt

‹› 60 Nm + 90° (1/4) additional turn.

‹› Replace

‹› To loosen or tighten, use counter hold tool (T10044) (with 5 mm spacers), or Counter holder tool (T10069).

10

Washer

11

Drive Plate

‹› Removing and installing, refer to => [ Drive Plate ] See: Service and Repair/Drive Plate.

12

Bolt

‹› 23 Nm

Transmission and Drivetrain > Flex Plate > Component Information > Specifications > Page 4153

[PREV PAGE] [NEXT PAGE]