Passat Sedan 4Motion V6-2.8L (ATQ) (2003)
Lock Carrier: Procedures
Lock Carrier And Front Bumper Reinforcement, Moving to Service Position
Lock carrier and front bumper reinforcement, moving to service position from 10.00
Performing service position
-
Remove front bumper. See: Bumper/Front Bumper/Front Bumper Cover / Fascia/Service and Repair/Front Bumper Cover, Assembly Overview
-
Remove noise insulation See: Sound Proofing / Insulation/Service and Repair
-
Remove air intake air duct between lock carrier -1- and air cleaner at lock carrier.
-
Remove bolt -5- on bumper carrier -4- and install Guide rodes 3411 -6- on left and right longitudinal.
-
Remove bolts -2- and -3-
-
Lock carrier -1- can be pulled forward approx. 10cm on 3411 guide rods -2-
Resetting service position
Resetting lock carrier is same in reverse order.