Passat Sedan 4Motion V6-2.8L (ATQ) (2003)
Replace sanding disc prior to moving to next brake disc surface.
Clean all brake disc friction surfaces using soap and water solution.
Deglaze and Clean Brake Pads
^
Place 80-grit sand paper on flat hard surface.
^
Carefully sand brake pads until the surface glazing is removed.
^
Measure brake pad thickness using metric scale. If any brake pad is equal to or less than 50 percent of original thickness of new brake pads
(excluding backing plate):
^
Replace all 4 brake pads on axle you are servicing.
Tip:
See appropriate Repair Manual in ElsaWeb for new brake pad thickness dimensions.
Reassembly
^
Install brake discs, brake pads, brake calipers and wheels. See appropriate Repair Manual in ElsaWeb for vehicle you are servicing.
^
Road test vehicle to confirm vibration concern is corrected.
No Special Parts required.