Passat Sedan 4Motion V6-2.8L (ATQ) (2003)
-
Install engine support bridge 10-222 A as shown.
-
Hook engine to engine support bridge 10-222 A and engine support adapter 10-222 A/3 at front and rear lifting eyelets and pre-tension slightly.
-
Slightly pre-tension engine using engine support bridge 10-222 A spindles.
-
Remove bolt for oil dip stick guide tube from cylinder head - arrow - and remove guide tube upward.
-
Drain coolant.
-
Bring lock carrier into service position. See: Body and Frame/Lock Carrier/Service and Repair/Procedures
-
Remove torque support from upper part of oil pan at front.
-
Remove coolant pipe on front of engine from oil pan.
-
Disconnect coolant lines from oil cooler under oil filter.
-
Disconnect connector from oil pressure switch.