Passat Sedan 4Motion V6-2.8L (ATQ) (2003)
Tail Lamp: Service and Repair
Rear Light Housing - Wagon, Removing and Installing
Rear Light Housing - Wagon From 10.00, Removing And Installing
Removing
-
Switch off all electrical consumers, switch off ignition and remove ignition key.
-
Open rear side storage flap.
-
Remove bulb holder.
-
Remove four screws -arrows- and remove housing.
Installing
-
Insert housing into opening.
-
Install and tighten securing nuts, 3 Nm (27 in lb).
-
Install bulb holder and reconnect electrical connectors.
-
Close rear side storage flap.