Passat Sedan 4Motion V6-2.8L (ATQ) (2003)
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
If specified value is obtained:
-
Check voltage supply of throttle valve control module and wiring to control module.
-
Check Throttle Position (TP) Sensor -G79- and Sender -2- for accelerator pedal position -G185-. See: Sensors and Switches - Computers and
Control Systems/Throttle Position Sensor/Testing and Inspection
If voltage supply and wires are OK:
-
Replace Motronic Engine Control Module (ECM) -J220-.
Checking voltage supply and wiring to control module
-
Connect multimeter to connector terminals 2 + 6 for voltage measurement.
-
Switch ignition on.
Specified value: at least 4.5 V
-
Switch ignition off.
-
Connect test box to control module wiring harness, connect test box for wiring test. See: Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/Scan Tool Connecting/With Generic Scan Tool/Test Box, Connecting For Wiring Test
-
Check wires between test box and 6-pin connector for open circuit according to wiring diagram:
Terminal 1 + socket 92
Terminal 2 + socket 83
Terminal 3 + socket 117
Terminal 4 + socket 84
Terminal 5 + socket 118
Terminal 6 + socket 91
Wire resistance: max: 1.5 Ohms
-
Also check wires for short circuits to each other, to vehicle Ground (GND) and to B+.
Specified value: Infinity Ohms
If no malfunctions are found in wires:
-
Check voltage supply of Engine Control Module (ECM). See: Engine Control Module/Testing and Inspection/Engine Control Module (ECM)
Voltage Supply, Checking/With Generic Scan Tool
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes