Passat Sedan 4Motion V6-2.8L (ATQ) (2003)
-
Connect multimeter between terminal 1 and 2 for resistance measurement.
Specification: approx. 0 Ohms
-
Press in clutch pedal.
Expected value: infinity Ohms (no flow of electricity)
If specified value is not obtained:
- Replace Clutch Pedal Position (CPP) switch.
If the specified value is met:
-
Connect multimeter between terminal 1 and Ground (GND) to make voltage measurement.
Specification: at least 11.5 V
If specified value is not obtained:
-
Check wire between 2-pin connector terminal 1 and central electrical system (see wiring diagram).
If the specified value is met: