volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Ignition Coil, Checking|Page 4292 > < Ignition Coil, Checking|Page 4290
Page 4
background image

-

Connect V.A.G 1527 voltage tester to terminals 2 + 3 of connector.

-

Operate starter and test ignition signal from Engine Control Module (ECM).
LED should flicker.

-

Repeat test between terminals 2 + 4 and 2 + 5.

If LED does not flicker:

-

Connect test box to control module wiring harness, connect test box for wiring test.  See: Computers and Control Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes/Scan Tool Connecting/With Generic Scan Tool/Test Box, Connecting For Wiring
Test

Vehicles with engine code AHA

-

Check wires between test box and 5-pin connector for open circuit according to wiring diagram.
Terminal 3 + socket 71
Terminal 4 + socket 78
Terminal 5 + socket 70
Wire resistance: max: 1.5 Ohms

Vehicles with engine code ATQ

-

Check wires between test box and 5-pin connector for open circuit according to wiring diagram.
Terminal 3 + socket 102

Ignition Coil, Checking|Page 4292 > < Ignition Coil, Checking|Page 4290