Passat Sedan 4Motion V6-2.8L (ATQ) (2003)
Ignition Switch Lock Cylinder: Service and Repair
Lock Cylinder, Removing and Installing
Lock Cylinder, Removing And Installing
CAUTION!
Before beginning repairs on the electrical system:
-
Obtain the anti-theft radio security code.
-
Switch the ignition off
-
Disconnect the battery Ground (GND) strap.
-
After reconnecting battery, re-code and check operation of anti-theft radio.
Removing
-
Remove upper and lower steering column switch trim. Steering column switches, removing.
-
Where applicable, carefully disconnect electrical connection for the induction coil for anti-theft immobilizer from lock cylinder.
NOTE: If equipped, the induction coil for anti-theft immobilizer is integrated with the lock cylinder and cannot be serviced separately.
-
Insert ignition key in lock cylinder and turn to "ON" position.
Position of key in lock cylinder:
1
-
Position "OFF"
2
-
Position "ON / DRIVE"
3
-
Position "START"