Passat Sedan 4Motion V6-2.8L (ATQ) (2003)
-
Install support bar 10-222A together with legs 10-222 A/1 and adapter 10-222 A/18.
-
The longer side of adapter 10-222 A/18 faces forward.
-
Secure third spindle 10-222 A/10 with additional hook 10-222 A/2 on lifting eye at rear left of engine.
-
Hook second additional hook 10-222 A/2 on lifting eye at rear right of engine.
Continued for all vehicles
-
Take weight of engine/transmission assembly on the spindles.
-
Remove wheels.
-
Remove noise insulation tray.
Vehicles with automatic headlight range control
-
Unclip clamp for coupling rod -1- for left front level control system sensor -G78- from track-control link -2-.
Continued for all vehicles
-
Before loosening subframe, check that at least holes -1- and -2- align using special tool 3393.
-
If this is not the case, perform axle alignment measurements after installing the sub-frame!